[EthernetIP Device] Rack and Slot inputs not visible after enabling routing switch

[zhangjl-gitee]

When configuring an EthernetIP device in Fuxa, the rack and slot input fields do not appear even after enabling the routing switch. This persists even after removing the *ngIf="data.device.property.options" condition in the template code.

• [Fuxa Version: 1.2.4 (latest stable) ]

• [OS: Windows 11 ]

• [Device Type: EthernetIP ]
  

[unocelli]

Hi, did you build the frontend?

[zhangjl-gitee]

Yes, I have built the frontend. I followed the normal building process, and other parts of the interface seem to be working fine. But when dealing with the EthernetIP device configuration, the rack and slot input fields still don't show up even after I've made some adjustments to the relevant code, such as removing the *ngIf="data.device.property.options" condition. I've also checked the relevant code logic and the DOM rendering situation through the browser's developer tools, but I still haven't found the cause of the problem.

[zhangjl-gitee]

When configuring an EthernetIP device in Fuxa, after enabling the routing switch, input fields labeled "rack" and "slot" appear on the page. I entered common default values, such as rack = 0 and slot = 1. Subsequently, the device was successfully connected, and the status indicator turned green. However, even in the successfully connected state, the data from the device cannot be read. The following points need to be confirmed now:
Do the labels of the input fields truly correspond to the rack and slot numbers?
Are additional configurations required, such as the device address and network routing table?


I attempted to modify the exported JSON file by adding the type property, but I'm still unable to read data.

[zhangjl-gitee]

Address format adjusted and type property added; attached the device's JSON configuration file for further analysis
fuxa-devices.json

[zhaojianfei08]

I have the same problem with AB plc，if you have some information pls tell me know，thx